12 63 586 Replacing power distribution box

Necessary preliminary tasks: 

• Remove DME CONTROL UNIT .

Removal: 

Release lock (1).

Detach cable (3) from equipment holder (4).

Carefully pull out power distribution box (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock connector (1) and remove.

Remove power distribution box (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Connect the connector (1) to the power distribution box (2).

Connectors (2) must snap audibly into place.

Courtesy of BMW OF NORTH AMERICA, INC.

Route cable (3) in the equipment holder (1).

Push the power distribution box (2) into the equipment holder (1) and snap into place.

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work: 

• Install DME CONTROL UNIT .