11 14 005 Replacing front crankshaft seal

Special tools required:

Necessary preliminary tasks:

Removal:

Drive in the crankshaft seal (1) by approx. 1 cm in the marked area by using a punch.

Courtesy of BMW OF NORTH AMERICA, INC.

Use special tool 2 298 505 to lift out the crankshaft seal (1).

Do not scratch sealing surface against engine block.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Clean special tool 11 8 801 and coat it with new engine oil.

Fasten special tool 11 8 801 with 11 8 802 on the crankshaft.

Courtesy of BMW OF NORTH AMERICA, INC.

Attention!

Touching the sealing lip (on the inside) of the crankshaft seal is not permitted.

Coating the outside of the crankshaft seal with oil is not permitted.

Carefully slide the crankshaft seal (1) in a rotational movement straight onto the special tool 11 8 801 until flush with the crankcase.

Courtesy of BMW OF NORTH AMERICA, INC.

Draw in the crankshaft seal using special tool 11 8 803 and 11 8 804.

Screw in special tool 11 8 803 until it is flush with the crankcase.

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work: