51 71 478 Removing and installing/replacing the rear left or right wheel arch trim

Special tools required:

NOTE: For clarity the vehicle is only partially pictured.

Removal:

Remove the blind rivet (1).

Disengage the trim (2) from the clips (3) around the side panel.

Loosen and remove the trim (1) from the latch mechanisms on the bumper.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

NOTE: Replace faulty clips (3).

Insert the trim (2) and engage with the clips (3).

Engage the trim (2) with the latch mechanisms on the bumper.

Install the blind rivet (1) using special tool 00 2 230 .

Courtesy of BMW OF NORTH AMERICA, INC.