51 16 160 Removing and installing (replacing) center console trim

Special tools required:

When working on trim panel components, make sure that visible surfaces are not scratched or damaged (e.g. by sharp-edged tools).

Necessary preliminary work:

Removal:

Release screw (1).

Lever out trim (2) from clamps (3) using special tool 00 9 325 .

Lift trim (2) upwards.

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Do not disconnect plug connection.

Release screws (1).

Remove switch for electromechanical parking brake (2) from trim (3) and put down.

Disconnect associated plug connections and remove trim (3).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Install trim (3) and connect the corresponding plug connections.

Install switch for electromechanical parking brake (2).

Tighten down screws (1).

Tightening torque 61 31 4AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Engage trim (2) in clamps (3).

Tighten screw (1).

Tightening torque 51 16 7AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work: