Installing washer fluid reservoir

• Connect all connectors (1).
• Clip the cable into the washer fluid reservoir (3) (arrows).
• Connect hose line (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Feed in the washer fluid reservoir (1) towards the back in the holders (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten down screw (2).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Washer fluid reservoir
  tightening torque		8 Nm

• Connect the hose pipe (1) of the headlight cleaning system.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Clip hose pipe (1) into the washer fluid reservoir (3).
• Clip the filler channel (1) downwards into the washer fluid reservoir (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE AIR DUCT ON THE INNER SIDE PANEL .
• Refer to INSTALLING THE TRIM ON THE SIDE PANEL .
• Refer to INSTALLING THE REAR SECTION OF THE FRONT WHEEL ARCH COVER .
• Refer to INSTALLING THE MOUNT OF THE HOOD SEAL .
• Refer to INSTALLING THE LID FOR THE WASHER FLUID RESERVOIR .
• Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
• Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT CENTER .
• Refer to INSTALLING THE FRONT RIGHT WHEEL .
• Refer to RESETTING THE TIRE PRESSURE MONITOR .