Secure the juncture shaft in front on the front axle differential
- Before installing the prop shaft on the front axle transmission, all 4 threads (1)
in the front axle transmission flange must be freed of possible residue and contaminations and cleaned.
- Replace screws.
Parts: Screws
- A drop of Loctite 270 (2)
must be given before the screw connection on each thread at the end of the respective screw (1)
.CONSUMABLE SPECIFICATION
High-strength screw lock, Loctite 270 10 ml, Tube 83 19 2 210 337 NOTE: TECHNICAL INFORMATION
After the screw connection of the front prop shaft, a 30 minute hardening time must be ensured before the vehicle is operated again. - Replace the bolts (arrows).
Parts: screws.
- Tighten the screws.
TIGHTENING TORQUES SPECIFICATION
| Prop shaft before the front axle differential | ||
| Replace screws. Joining torque and angle of rotation must be observed without fail. |
tightening torque | 25 Nm |
| Angle of rotation | 45° | |
- Before installing the prop shaft on the front axle transmission, all 4 threads (1)
in the front axle transmission flange must be freed of possible residue and contaminations and cleaned.
- Replace screws.
Parts: Screws
- A drop of Loctite 270 (2)
must be given before the screw connection on each thread at the end of the respective screw (1)
.CONSUMABLE SPECIFICATION
High-strength screw lock, Loctite 270 10 ml, Tube 83 19 2 210 337 NOTE: TECHNICAL INFORMATION
After the screw connection of the front prop shaft, a 30 minute hardening time must be ensured before the vehicle is operated again. - Position the propeller shaft in front on the front axle differential.
- Replace the bolts (arrows).
Parts: Screws
- Tighten screws (arrows).
TIGHTENING TORQUES SPECIFICATION
| Prop shaft before the front axle differential | ||
| Replace screws. Joining torque and angle of rotation must be observed without fail. |
tightening torque | 25 Nm |
| Angle of rotation | 45° | |