Install both tension struts from shock tower
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Install tension strut on shock tower
NOTE:
Driving without the strut brace/front-end strut or tension strut is not permitted.
- Version A:
- Install the tension strut (3) on the shock tower.
- Tighten down screws (1)
.TIGHTENING TORQUE SPECIFICATIONS
Tension strut on firewall M10x25 screw Tightening torque 56 Nm - Replace screws (2)
.
Parts: Screws
- Tighten down screws (2)
.TIGHTENING TORQUE SPECIFICATIONS
Tension strut to shock tower screw
Replace screws.Joining torque 56 Nm Angle of rotation 90° - Version B:
- Install tension strut (3) on the shock tower.
- Tighten down screw (1)
.TIGHTENING TORQUE SPECIFICATIONS
Tension strut on firewall M10x25 screw Tightening torque 56 Nm - Replace the screw (2)
.
Parts: Screw
- Tighten down screw (2)
.TIGHTENING TORQUE SPECIFICATIONS
Tension strut to shock tower screw
Replace screws.Joining torque 56 Nm Angle of rotation 90°