Install automatic transmission

NOTE: RISK OF DAMAGE
Damage to the transmission.
Damage to the transmission due to unapproved transmission oil.

Check for correct fit of fitting sleeves (1) .
Replace damaged lining sleeves.

Courtesy of BMW OF NORTH AMERICA, INC.
Transmission flange-mount.
Twist the torque converter until the bore of the torque converter is aligned with the bore of the drive plate.
Insert screws and tighten.

Courtesy of BMW OF NORTH AMERICA, INC.
Release screw (1) and screw (2) .
Remove the special tool 0 494 451 (24 4 160).

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: TECHNICAL INFORMATION
When assembling, it is essential to observe screwing sequences and tightening torques.
Non-compliance with the regulations can lead to damage.

Courtesy of BMW OF NORTH AMERICA, INC.
Replace screws.
Parts: Screws
Screw the torque converter onto the vertically arranged elongated hole (1) .
Turn the torque converter until the elongated hole (1) is visible in the opening.

Tighten down screw.

TIGHTENING TORQUE SPECIFICATIONS

Torque converter to flywheel
M10 Replace screws.	tightening torque	60 Nm

Tighten the screws (2) to (6) (torque converter on the flywheel) in the following tightening sequence:

Tightening sequence: (1-4-3-6-5-2)

The screw connection (1) is the vertically arranged elongated hole in the torque converter.

TIGHTENING TORQUE SPECIFICATIONS

Torque converter to flywheel
M10 Replace screws.	tightening torque	60 Nm

Fig 1: Torque Converter Screws Tightening Sequence

Courtesy of BMW OF NORTH AMERICA, INC.