1111 ENIGINE BLOCK (750i 2016-2019)
1111 TIGHTENING TORQUE OVERVIEW
| (ASA collar screw) M11 | ||
| M11x99... Replace screws Screw in hand-tight |
Joining torque | 20 Nm |
| Angle of rotation | 115° | |
| Angled screw connection to crankcase | ||
| M8x37 Flanged head screw 10.9 Flat-head screw 10.9 |
Joining torque | 10 Nm |
| Angle of rotation | 45° | |
| Bearing cap to crankcase (ASA (ASA) collar screw) | ||
| M11x99... Replace screws Screw in hand-tight |
Joining torque | 20 Nm |
| Angle of rotation | 115° | |
| Bearing cap to crankcase (ASA collar screw 10.9) | ||
| M8X70 Replace screw. |
Joining torque | 10 Nm |
| Angle of rotation | 55° | |
| Bearing screws for M10 cylinders 1-4 | ||
| M10 Clean the threads with a thread cutter. |
tightening torque | 46 Nm |
| Oil nozzle to crankcase | ||
| M12x1 | tightening torque | 10 Nm |
| Screw plug, main oil duct, rear, in V-space, right | ||
| M18x1.5 Replace gasket |
tightening torque | 55 Nm |
| Screw plug, oil/water | ||
| M22x1.5 Replace gasket |
tightening torque | 70 Nm |
| Special tool 11 8 930 to special tool 00 2 300 | ||
| M14x35 | tightening torque | 160 Nm |
| Special tool to crankcase | ||
| M8x35 | tightening torque | 20 Nm |
| Special tool to crankcase, rear | ||
| M10x35 | Tightening torque | 40 Nm |
| Threaded support sleeves | ||
| tightening torque | 6 Nm | |