Lower the headlining on the left or right (with sliding/tilting sunroof)
NOTE:
RISK OF DAMAGE
Electrostatic discharge.
Damage to or destruction of electrical components.
Electrostatic discharge.
Damage to or destruction of electrical components.
- Leave the electrical components in their original packaging until they are being installed. Only use the original packaging for returning the product. Always package removed components straight away.
- Read and comply with user information on using the associated special tool 12 7 060.
- Only tap the housings of electrical components. Do not tap pins or multi-pin connectors directly.
- Wear electrically conductive clothing and antistatic shoes (with ESD symbol).
- For additional information see: NOTES ON ESD (ELECTROSTATIC DISCHARGE) PROTECTION .
NOTE:
RISK OF DAMAGE
Careless handling of tools and sharp-edged components.
Scratches, surface damage.
Careless handling of tools and sharp-edged components.
Scratches, surface damage.
- Protect working area.
- Handle tools and components carefully.
Preliminary work
- Refer to REMOVING REAR INTERIOR ROOF LIGHT .
- Refer to REMOVING BOTH REAR VANITY MIRRORS .
- Refer to REMOVING BOTH FRESH AIR GRILLES OF THE HEADLINING .
- Refer to INSTALLING THE HOLDER ON LEFT OR RIGHT .
- Refer to REMOVING C-PILLAR TRIM PANEL .
- Refer to REMOVING THE B-PILLAR TRIM PANEL UPWARDS .
- Refer to REMOVING A-PILLAR TRIM PANEL .
- Refer to REMOVING THE SUN VISOR AND THE COUNTER SUPPORT .
- Refer to REMOVING THE ROOF FUNCTION CENTER (FZD) .
- Refer to REMOVING RIGHT HANDS-FREE MICROPHONE .
- Refer to REMOVING THE VANITY MIRROR LIGHT AT THE FRONT LEFT OR RIGHT .
- Refer to REMOVING THE COVERS FOR THE INTERIOR REARVIEW MIRROR .
- Refer to REMOVING THE INTERIOR REARVIEW MIRROR .
Precondition
The slide/tilt sunroof lid is open.
- Loosen screws (1).
- Unclip panel down (1) from the clips (2) and remove it.
- Equipment specification with rear air conditioning/vanity mirror at the rear:
Loosen screws (1) left and right.
- Release the headlining with the special tool 0 496 569 (00 9 325)
from the clips (1).
- Release headlining (1) with special tool from the clip (2) with the aid of a support person.
- Thread the headlining (1) out of the edge protection and put aside.
- Guide out the headlining at the respective edge protection.
- Lower the headlining and place it onto the head restraints as shown.