Install the rear blower
- Feed the rear blower (2) into the center console (3).
- Tighten the screws (1).TIGHTENING TORQUE SPECIFICATIONS
Rear blower to support screw Tightening torque 1.5 Nm - Insert the wiring harness (3).
- Clip in the cable clip (2).
- Position and connect the connectors (1).
- Correctly position the interior antenna (3).
- Tighten down screw (2).TIGHTENING TORQUE SPECIFICATIONS
Interior antenna Screw TS5x12 Tightening torque 1.5 Nm - Position and connect the connectors (1).
- Install both air ducts (1) correctly.