Installing The Rear Luggage Compartment Floor
Precondition
Bonding surfaces are cleaned.
NOTE:
TECHNICAL INFORMATION
When installing the new part, make sure that all bonding surfaces have sufficient adhesive.
When installing the new part, make sure that all bonding surfaces have sufficient adhesive.
- Apply adhesive K5 to the bonding surfaces.
ADHESIVE DESCRIPTION
Body adhesive K5 50 ml 83192158654 - Install new part.
- Set blind rivets N3 in area (1) .
CONSUMABLE SPECIFICATION
| Blind rivet N3 Ø 4 mm; clamping area 1-3 mm |
83190301421 |
Installing the EMC screw
- Drill the hole with a diameter of 4.2 mm after the adhesive completely hardens.
- Screw in the EMC screw.
- Seal the EMC screw with the sealant.
CONSUMABLE SPECIFICATION
| Sealant D1 (seam sealing) | 310 ml | 83422409985 |
NOTE:
Perform the steps on the left and right side.
- Set blind rivets in area (1) .
- Once the adhesive has hardened, install 1 x EMC screw in the area marked (2) .
CONSUMABLE SPECIFICATION
| screw EMC screw, SF Plus, M5x15 |
83190301639 |
Follow-up work
- Refer to ACTIVATE HIGH-VOLTAGE SYSTEM .
- Refer to INSTALL FLAP IN RIGHT LUGGAGE COMPARTMENT TRIM PANEL .