Remove the positive battery cable from the remote positive terminal to the alternator

• Release the cover (1)  at the detents (2)  .
• Remove the cover (1)  in an upwards direction.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Loosen nut (1)  .
• Feed out the positive battery cable (2)  from the stud bolt on the remote positive terminal.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Disengage the positive battery cable on the holders (1)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Unclip the cable clip (1)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Unlock and disconnect plug connections of the camshaft sensors (1)  .
• Loosen nut (3)  .
• Guide out the ground cable (2) 
• Loosen screw (4)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Remove cover (1)  .
• Loosen nut (2)  .
• Disconnect positive battery cable from alternator.
• Unlock plug connection (3)  and disconnect.
• Feed out positive battery cable and remove.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• CONNECTING THE LEFT CHARGE AIR LINE TO THE EXHAUST TURBOCHARGER .
• INSTALLING CLEAN AIR PIPE OF CYLINDER BANK 1 .
• CONNECTING THE RIGHT CHARGE AIR LINE TO THE EXHAUST TURBOCHARGER .
• INSTALLING THE RIGHT INTAKE FILTER HOUSING WITH THE RIGHT FRONT-END STRUT .
• INSTALLING CONTROL UNIT HOLDER FOR CYLINDERS 1 TO 4 .
• INSTALLING THE COVER OF THE RIGHT DME CONTROL UNIT .
• INSTALLING ACOUSTIC COVER .
• CONNECTING ALL BATTERY GROUND LEADS .