Adjust lock striker
NOTE:
TECHNICAL INFORMATION
The gap dimensions form the basis for these repair instructions and must be observed without fail.
For additional information see: BODY GAP DIMENSIONS .
The gap dimensions form the basis for these repair instructions and must be observed without fail.
For additional information see: BODY GAP DIMENSIONS .
NOTE:
Description is for left component only. Procedure on the right side is identical.
Precondition
The screws on lock striker are loosened so far that the lock striker can still be shifted.
NOTE:
TECHNICAL INFORMATION
The gap dimensions form the basis for these repair instructions and must be observed without fail.
For additional information see: BODY GAP DIMENSIONS .
The gap dimensions form the basis for these repair instructions and must be observed without fail.
For additional information see: BODY GAP DIMENSIONS .
- Adjust the height of the lock striker so that the door lock does not bump or drag.
- Move lock striker sideways in order to adjust the gap dimensions between door and rear quarter panel.
- Tighten down screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Lock striker | ||
| screw | Tightening torque | 21 Nm |