Removing the model inscription at the rear
NOTE:
RISK OF DAMAGE
Careless handling of tools and sharp-edged components.
Scratches, surface damage.
Careless handling of tools and sharp-edged components.
Scratches, surface damage.
- Protect working area.
- Handle tools and components carefully.
- Mask off the working area with adhesive tape.
- Heat the rear model inscription (1) carefully with a hot air blower and release it from the tailgate with the special tool 0 496 571 (00 9 327)
.TECHNICAL DATA SPECIFICATION
Heating using hot air blower Surface temperature 40°C... 50°C - Remove adhesive residue from the trunk lid.
CONSUMABLE SPECIFICATION
| Adhesive remover | 1 l, Can | 83110009712 |