65 12 210 Removing and installing (replacing) the radio receiver CHAMP
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION)
.
Necessary preliminary tasks:
- Disconnect BATTERY NEGATIVE CABLE
- Remove RADIO AND IHKA CONTROLS
Release screws (1).
Pull out the CHAMP (2) to the front.
Installation note:
Make sure CHAMP (2) is correctly seated on retaining lugs at the marked points.
Unlock plug connections (1) and disconnect.
Remove CHAMP (2).
Replacement:
Carry out VEHICLE PROGRAMMING/ENCODING .
For vehicles with Teleservices optional equipment:
- Update services via menu in the central information display.