11 23 010 Removing and installing/replacing vibration absorber (S63T 0)
Special tools required:
Necessary preliminary tasks:
- Remove charge air cooler on left and right. See 17 51 001 REMOVING AND INSTALLING/REPLACING LEFT CHARGE AIR COOLER (S63 B44 T 0) and 17 51 001 REMOVING AND INSTALLING/REPLACING RIGHT CHARGE AIR COOLER (S63 B44 T 0) .
- Remove DRIVE BELT for air conditioning compressor for the air conditioning
- Remove alternator DRIVE BELT
- Remove belt pulley for A/C system
Release screw (1).
Tightening torque 11 28 1AZ .
Remove belt tensioner with idler pulley (2).
Secure special tool 11 8 090 with three screws (1) to vibration damper.
Secure special tool 11 8 090 with belt tensioner bolt (2) to timing case cover.
Tightening torque 11 28 1AZ .
NOTE:
A 3/4 inch tool is needed to release the central bolt.
Release central bolt on vibration damper.
Secure central bolt with special tool 00 9 140 or 11 3 460 .
Position special tool 11 3 460 on special tool 11 8 090 .
Adjust special tool 11 9 453 on special tool 11 9 454 using clamping screw to 0° on scale.
Tightening torque 11 23 1AZ .
Assemble engine.