51 13 316 Removing and installing or replacing trim strip on gutter strip at left or right

Undo edge protection (1) and gasket (2) in trim strip (3) area.

Release screws (4).

Fig 1: Identifying Edge Protection And Gasket

Courtesy of BMW OF NORTH AMERICA, INC.

Carefully undo trim strip (1) from A-pillar.

Feed out entire length of rubber seal (2) from trim strip (1).

Carefully remove trim strip (1) from edge protection (3).

Fig 2: Identifying Trim Strip And Rubber Seal

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

• Feed trim strip (1) into edge protection in area (A).
• Insert rubber seal (2) into trim strip (1)
• Fasten trim strip (1) to A-pillar
• Tighten screws of trim strip (1).
• Fit gasket (3) on trim strip (1)
  Fig 3: Identifying Trim Strip, Gasket And Rubber Seal

  Courtesy of BMW OF NORTH AMERICA, INC.