51 14 010 Removing and installing/replacing rear BMW badge

Special tools required:

00 9 322

IMPORTANT: The notes on component bonding with double-sided adhesive tape serve as the basis for this repair instruction and must be observed without fail. See 51 00... NOTES ON COMPONENT BONDING ADHESIVE TAPE .

Carefully heat BMW badge (1) with hot air blower and lever out with special tool 00 9 322 .

Fig 1: Identifying Special Tool 00 9 322

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Pull liner* off adhesive tape (1).

Position plate over guides (2 and 3) and press down firmly.

* Liner is the protective film on a new badge.

Fig 2: Identifying Adhesive Tape And Guides

Courtesy of BMW OF NORTH AMERICA, INC.