67 62 000 Removing and installing or replacing flat motor for front left or right power window regulator

Necessary preliminary tasks:

Unfasten screws (2).

Tightening torque 67 62 1AZ .

Remove flat motor (1) from power window regulator.

Fig 1: Identifying Power Window Regulator Flat Motor And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Make sure drive shaft (2) is correctly seated in mounting (1) at power windows (3).

Fig 2: Identifying Drive Shaft, Mounting And Power Windows

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

An initialization must be carried out in order to activate anti-trap mechanism.

OBSERVE information on initializing power window regulator. See 67 62... NOTES ON INITIALIZING POWER WINDOWS .