63 10 004 Adjusting headlights

COMPLY  with test prerequisites for headlight adjustment.

Remove lid (1) and turn sealing cap (2) in direction of arrow and remove.

Fig 1: Turning Sealing Cap

Courtesy of BMW OF NORTH AMERICA, INC.

Carry out headlight adjustment at adjusting screws below openings (1) and (2).

1. Adjusting screw primarily for vertical adjustment
2. Adjusting screw primarily for lateral adjustment

Attention: for height adjustment of LED headlights F01, F02, F03! 

If necessary, required height adjustment may only be carried out through height adjustment of LED headlights (turn adjusting screw (1) anticlockwise)! 

Fig 2: Identifying Headlight Vertical And Lateral Adjustment Screws

Courtesy of BMW OF NORTH AMERICA, INC.

1. LED headlight adjusted too low: 

   Adjust LED headlight higher to correct dimension at adjusting screw (1) (turn adjusting screw (1) anticlockwise).

2. LED headlight adjusted too high: 

   Adjust LED headlight at adjusting screw (1) too low  (turn adjusting screw (1) clockwise). Only afterwards  adjust LED headlight higher to correct dimension at adjusting screw (1) (turn adjusting screw (1) anticlockwise).

   After headlight adjustment: 

   Perform reference run. To do so, switch the LED headlight off and on. Check again headlight adjustment.