51 45 075 Removing and installing/replacing support for dashboard

Necessary preliminary work: 

• Remove instrument panel trim. See 51 45 030 REMOVING AND INSTALLING INSTRUMENT PANEL TRIM .
• Unclip wiring harness
• Only if equipped with Head-Up Display optional equipment: 
  • Remove HEAD-UP DISPLAY
    Fig 1: Identifying Nuts On A-Pillar And Tunnel

    Courtesy of BMW OF NORTH AMERICA, INC.

Release nuts (1) on A-pillar.

Tightening torque 51 45 2AZ .

Release screws (2) on tunnel.

Tightening torque 51 45 3AZ .

Release screws (1) on steering column support (2).

Tightening torque 51 45 1AZ .

Release screws (3) on steering column (4).

Tightening torque 32 31 1AZ .

Release screw (1) on earth connection.

Release screw (2) on dashboard trim holder (3).

Release screws (1) on dashboard trim holder (2).

Remove dashboard support and if necessary feed out through front passenger door.