66 53 013 Calibrating reversing camera
NOTE:
Calibration of reversing camera must be carried out after the following work:
- Removal and installation/replacement of reversing camera
- Body repair work at rear end of vehicle
- Adjusting work at tailgate
IMPORTANT:
Follow instructions and specifications in procedure.
To obtain an optimum result, always adhere to the following conditions:
To obtain an optimum result, always adhere to the following conditions:
- Vehicle standing level on headlight aiming station
- Rear seat bench is unoccupied
- Do not swap seats during calibration
- Steering wheel in straight-ahead position
- Do not move steering wheel
NOTE:
Also switch on reversing camera by means of PDC button.
Calibration can only be carried out with the BMW diagnosis system.
Use of a special tool is no longer required from 09/2011!
Service functions:
- 04 Driver assistance
- All-round vision camera
- Calibration and teaching in for all-round vision camera