32 00 150 Carry out Kinematics Diagnosis System wheel alignment with vehicle load up to design position
Attention!
Carry out wheel alignment with DIN load only (refer to TECHNICAL DATA (NORMAL POSITION) ):
- If the technical prerequisites for alignment with ride height input are not fulfilled
- If the vehicle in question is a damaged vehicle
NOTE:
- Read and comply with GENERAL INFORMATION AND DEFINITIONS .
- Read and comply with GENERAL CHASSIS DEFINITION .
- Update KDS DATA STATES .
- Check compliance with TEST CONDITIONS , repair vehicle if necessary.
- If necessary, prepare vehicle hoist.
- Drive vehicle onto vehicle hoist.
NOTE:
The front and rear wheels must be positioned centrally on the rotary and sliding plates.
NOTE:
Rotary plates may vary from illustration depending on the manufacturer!
NOTE:
Vehicles with active steering:
NOTE:
Start up active steering prior to wheel alignment!
NOTE:
On vehicles with rear axle slip angle control:
NOTE:
The service function "Moving HSR actuator to the center position" is included in the active steering start-up.
- Attach pickup/ride height marks to vehicle (observe specifications from the various equipment manufacturers).
- Enter customer and vehicle data
- Identify chassis version and select vehicle
- Enter tire inflation pressure and tread depth
- Move VEHICLE INTO DESIGN POSITION
- Install brake pedal tensioner
- Remove locking pins from both rotating and sliding plates.
- Perform input measurement in accordance with equipment manufacturer's instructions.
- If necessary, adjust FRONT AXLE AND REAR AXLE
- Perform output measurement in accordance with equipment manufacturer's instructions.
- Save and print out test record.
- Insert locking pins into both rotary and sliding plates
- Remove chassis/wheel alignment system