41 61 014 Adjusting Engine Compartment Lid (Vehicles With Active Pedestrian Protection)

WARNING: Danger of injury!
The battery earth lead must be disconnected on vehicles with active pedestrian protection!

The 41 00... BODY GAP DIMENSIONS specified serve as the basis for the adjusting procedure.

Minor corrections (realignment work) are permitted if the existing adjustment options are not sufficient.

Make unpainted surfaces visible by also moving the hinges. Touch these up in the appropriate color.

Necessary preliminary tasks:

Clamp off battery earth lead.

NOTE: Stop screw must not be damaged or missing. If necessary, replace engine compartment lid hinge.
The stop screw is preset and must not be used to adjust the engine compartment lid.

Courtesy of BROWN, BOVERI & CO., LTD.

Slacken nuts (1) of hinges on left and right.

Tightening torque: 41 61 1AZ .

NOTE: If adjustment range is not sufficient, slacken screws on body and slide hinge (see "Height adjustment at hinge" below).

Courtesy of BROWN, BOVERI & CO., LTD.

Adjust engine compartment lid sideways and lengthways.

Strikers must snap into place in engine compartment lid catch.

Courtesy of BROWN, BOVERI & CO., LTD.

Height adjustment at hinge:

Slacken screws (1) and adjust engine compartment lid.

Tightening torque: 41 61 2AZ .

NOTE: For better understanding; the active pedestrian protection is shown here without actuator.

Courtesy of BROWN, BOVERI & CO., LTD.

Height adjustment at strikers:

Unclip the anti-twist lock (1).

Adjust height by turning the striker (2).

Height adjustment of engine compartment lid to side panel by means of STOP PAD .

NOTE: The engine compartment lid is correctly adjusted in the front section by a combination of pulling the strikers and pressing the stop pads.
Incorrect adjustment results in either wobbling of the bonnet or sluggish unlocking.

Courtesy of BROWN, BOVERI & CO., LTD.

IMPORTANT: Check function of retaining hook.

After Installation note:

Tighten all screws and nuts to specified torque.
Touch up unpainted surfaces in the appropriate color.
If necessary, adjust front side panels.