41 33 040 Replacing Front Left Or Right Side Wall Holder
Side wall removed.
Transfer the systematic diagram onto the respective holder version.
General information:
Follow procedure for REPAIR STAGE 2 .
The following new body parts are required (see the applicable BMW parts catalogue):
- (1) Holder, side wall, front (variant 1)
- (2) Holder, side wall, front (variant 2)
Following CONSUMABLES are required:
Material Quantity Adhesive K5a 1 Blind rivets N3 2 Cleaning agent R1 1 Removal of side wall holder (variant 1):
Release welded connections in areas (1) and remove holder (2).
Preparation of new part:
Adjust new part in conjunction with side panel in front to fit.
In area of bonding surfaces (1), set 2 4.2 mm dia. bores (2) for blind rivetsN3.
Remove new part and deburr holes.
IMPORTANT: Do not grind bonding surfaces down or off.Installation of side wall holder
Clean all bonding surfaces with CLEANING AGENT R1 .
Apply adhesive to bonding surfaces.
Install new part and rivet with blind rivets.
Removal of side wall holder (variant 2):
Release welded connection in area (1) and remove holder (2).
Preparation of new part:
Fit in new part.
In area of adhesive surface (1), drill a 4.2 mm dia. bore (2) for blind rivet N3.
Remove new part and deburr holes.
IMPORTANT: Do not grind bonding surfaces down or off.Installation of side wall holder:
Clean all bonding surfaces with CLEANING AGENT R1 .
Apply adhesive to bonding surface.
Install new part and rivet with blind rivet.