41 21 203 Replace B-Pillar, Outer Left
Observe procedure of REPAIR STAGE 3 .
Read contents of BODY, GENERAL .
Use only approved SPOT-WELDING APPARATUS for repairs.
The following new body parts are required (see the applicable BMW parts catalogue):
- (1) A-pillar with entrance
- (2) Shaped part, B-pillar, outer front (not shown)
- (2) Shaped part, B-pillar, outer rear (not shown)
Removing the B-pillar
Mark severance cuts in accordance with specified dimensions and cut.
Dimension a = approx. 90 mm after centerpoint of 20 mm dia. hole.
Dimension b = approx. 90 mm before centerpoint of 20 mm dia. hole.
Dimension c = approx. 160 mm from edge of roof frame.
Open welded connections in areas (1).
Release B-pillar from cavity sealings (2) and remove.
New part preparation
Mark severance cuts on new parts in accordance with severance cuts on vehicle and cut.
Prepare REINFORCEMENT PLATES at severance cuts.
Fit in new part.
Installation of B-pillar
Coat cavity sealings with sealant: Refer to 41 00... INSTALLING CAVITY SEALING (EXPANDED) and 41 00... INSTALLING CAVITY SEALING (NOT EXPANDED)
Install and weld new parts and REINFORCEMENT PLATES .