51 13 316 Removing and installing or replacing trim strip on roof gutter at left or right
Special tools required:
- 00 9 325
Make sure that body is not damaged.
Starting from the front, use special tool 00 9 325 to remove trim strip (1) from clips (2).
Installation note:
To avoid leaks and noises, check all clamps (2) for visible damage.
Replace faulty clamps (2).
Fit trim strip (1) with pre-installed clips (2).
Installation note:
Gaskets (1) must not be damaged.
IMPORTANT:
- Carry trim strip by its middle section only (risk of damage)
- Perform installation work with a second person helping
- Pre-positioning of trim strip
- Ensure gutter strip runs parallel to side frame (risk of breakage)