54 12 003 Adjusting glass slide/tilt sunroof panel

Special tools required:

00 9 315
00 9 340

Installation note:

Microencapsulated screws (Loctite) must be replaced and may not be reused
Screw connection must be completed within 20 minutes (start of curing)
Microencapsulated screws must not be retightened
Clean thread of nut beforehand in event of repeated use

Necessary preliminary tasks:

Remove both GAITERS

Ideal setting:

Distance:
- Distance A of glass slide/tilt sunroof panel (1) to roof (2) must be the same at the circumference
- A = circumference 6.0 ± 0.5 mm
Height:
- Front - flush to 0.75 mm deeper
- Rear - flush to 1.5 mm higher

NOTE: Measure front and rear height adjustment over the entire cover width.
Height over the entire cover width must lie within tolerance.
Measuring range only at straight range of glass slide/tilt sunroof panel.

Courtesy of BMW OF NORTH AMERICA, INC.

Loosen left and right screws (1).

NOTE: For setting screws (1), only slacken until glass slide/tilt sunroof panel (2) can just be adjusted.

Tightening torque: 54 12 01AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Height adjustment:

Check height of glass slide/tilt sunroof panel (1) in relation to roof (2) with special tool 00 9 315.

Press glass slide/tilt sunroof panel upwards and downwards until the ideal position has been reached.

Setting distance:

Check distance between gasket and roof (2) with special tool 00 9 340.

It must be possible to slide the special tool against the same level of resistance.

Slide glass slide/tilt sunroof panel forward and back until ideal setting is reached.

Courtesy of BMW OF NORTH AMERICA, INC.

Check function and adjustment.

Perform INITIALIZATION of glass slide/tilt sunroof