61 31 197 Removing and installing/replacing center console operating facility
Necessary preliminary tasks:
Version with manual gearbox only:
- Partially remove GEARSHIFT LEVER GAITER
Version with automatic transmission only:
- Remove COVER FOR SELECTOR LEVER
IMPORTANT:
Risk of damage!
Center console operating facility must not be pried out from the outside.
Center console operating facility must not be pried out from the outside.
NOTE:
Graphic shows example of F20 with automatic transmission.
- Reach under front section of operating facility (1).
- Press front latch mechanism in direction of arrow and simultaneously raise operating facility (1) towards top.
- Disconnect associated plug connection and remove operating facility (1).
NOTE:
Latch mechanisms (1) must not be damaged or missing.
Make sure operating facility is correctly fitted in center console.
Make sure operating facility is correctly fitted in center console.
In case of replacement, remount operating unit cover:
Release latch mechanism (1) and remount cover (2), depending on equipment.
NOTE:
Latch mechanisms (1) must not be damaged or missing.