51 13... Removing and installing/replacing partition wall attachment, right
Turn locks (1) 90° counterclockwise.
Unlock catch (3).
Remove cover (2).
Release clip (1).
Turn snap fastener (2) approx. 90° counterclockwise.
Disconnect plug connection (3) and feed out cable.
Release screws (6) and feed out attachment (5).
Replacement:
Twist sensor (4) approx. 90° counter-clockwise and remove.
Installation note:
The following versions may be fitted:
- Attachment (1) without air filter
- Attachment (1) with air filter (2)
- Attachment (1) with air filters (2 and 3)
Attachment (1) must only be fitted with air filter (2).
If necessary, remove air filter (3) and/or attach air filter (2) at position illustrated.
Installation note:
Grille (1) on sealing frame (2) must be fitted.
If necessary attach new grille (1).
Grille (1) is pressed onto sealing frame (2) by air filter on attachment.
Grille (1) in conjunction with the air filter on the attachment prevents foreign objects entering.