22 11 100 Replacing right engine support arm (230i coupe/convertible, RWD)

Necessary preliminary tasks:

Refer to SECURING ENGINE IN INSTALLATION POSITION .
Remove underbody protection at the front and rear. Refer to REMOVING AND INSTALLING/REPLACING UNDERBODY PROTECTION (FRONT) , and REMOVING AND INSTALLING/REPLACING REAR UNDERBODY PROTECTION . .

Removal:

Release screws (1).

Remove engine support arm (2).

G10103428

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Install engine support arm (2).

Tighten down screws (1).

Tightening torque 22 11 3AZ .

G10103428

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work:

Installing front and rear underbody protection. Refer to REMOVING AND INSTALLING/REPLACING UNDERBODY PROTECTION (FRONT) , and REMOVING AND INSTALLING/REPLACING REAR UNDERBODY PROTECTION .