Remount LED module for cornering light at left and right
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Description is for left component only. Procedure on the right side is identical.
Removing LED module for the cornering light
- Loosen screws (1) on the LED module for the cornering light (2) .
- Pull LED module for the cornering light (2)
out of the headlight.
- Unlock and disconnect connector (1) .
- Remove LED module for the cornering light (2)
.
Installing the LED module for the cornering light
- Check seal (3)
on the LED module for cornering light (2)
for damage and replace it if necessary.
The seal (3) may not be damaged or be missing.
- Connect connectors (1)
and lock.
- Position the LED module for cornering light (2) in the headlight.
- Tighten the screws (1)
.TIGHTENING TORQUE SPECIFICATIONS
LED cornering light module to headlight Screw Tightening torque 1.6 Nm