Replace rear left or right shock absorber (EDC) (X2 2018-2023)

Special tools required: 

• 33 0 040

Attention! 

• On replacement of shock absorber, replace additional absorber!
• In vehicles up to 06/2017, the shock absorbers must always be exchanged in pairs. (Shock absorbers from 06/2017 have a different alignment)

Necessary preliminary work: 

• Refer to REMOVING REAR SHOCK ABSORBER .

Removal: 

Release adapter plate (2) from support bearing.

Disconnect connector (1) from shock absorber.

Remove adapter plate (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Release nut (1) with special tool 33 0 040, reversible ratchet with extension and socket SW10.

Remove spring strut mounting (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Remove gasket (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Remount stone guard (1).

Installation note: 

Check stone guard and replace if necessary.

Courtesy of BMW OF NORTH AMERICA, INC.

Part:  Replace auxiliary damper with protective tube (3).

Connect additional absorber with protective tube (3) onto shock absorber.

Connect gasket (2) and support bearing (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Part:  Replace nut (1).

Tighten down nut (1) with special tool 33 0 040, reversible ratchet with extension, socket SW10 and torque wrench with ring spanner attachment SW21.

Tightening torque 33 52 3AZ .

Impact screwdrivers are prohibited!

Risk of damage inside the shock absorber! 

Courtesy of BMW OF NORTH AMERICA, INC.

Connect connector (1) to shock absorber.

Fit adapter plate (2) on support bearing and engage.

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work: 

• Refer to INSTALLING REAR SHOCK ABSORBER .