Remove safety pressure switch
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
Preliminary work
- Refer to SUCTIONING THE AIR CONDITIONING .
- Refer to REMOVING REAR HOOD SEAL .
- Refer to REMOVING THE GUTTER STRIP ON THE WINDSCREEN ON THE LEFT AND RIGHT .
- Refer to REMOVING FRONT WINDSHIELD PANEL COVER .
- Refer to REMOVING LEFT AND RIGHT WIPER ARM .
- Refer to REMOVING THE REAR COWL PANEL .
- Refer to REMOVING THE HOOD SEAL AT THE SIDE ON THE LEFT AND RIGHT .
- Refer to REMOVING THE SEAL FOR THE FRONT CENTER HOOD .
- Refer to PARTIALLY REMOVING THE WHEEL ARCH TRIM ON THE FRONT LEFT AND RIGHT .
- Refer to PARTIALLY REMOVING THE WHEEL ARCH COVER ON THE FRONT LEFT AND RIGHT .
- Refer to REMOVING TEMPERATURE SENSOR .
- Refer to REMOVING FRONT BUMPER COVER .
- Refer to REMOVING RIGHT HEADLIGHT .
- Loosen expanding rivet (1).
- Loosen screw (2).
- Remove the cover (3).
- Unlock and open the holder (1).
- Loosen screw (1).
- Remove the refrigerant line (2) and set it aside.
- Loosen screw (1).
- Slide the cowl lower part (2) slightly to the side,
- Open the holder (1).
- Slide the cable (2) slightly to the side.
- Detach the refrigerant line (3) from the holder (4).
- Set the refrigerant line (3) aside.
- Unlock and disconnect connector (1).
- Loosen the safety pressure switch (2).