Cleaning evaporator (X2 2018-2023)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

2 413 653

WARNING: When handling cleaning agent, observe following protective measures:
Wear protective rubber gloves and protective goggles.
If cleaning agent comes into contact with eyes or skin, wash immediately with lots of water.
OBSERVE NOTES FOR HANDLING CLEANING AGENTS .

NOTE: For information on cleaning agent and rinsing again, refer to INFORMATION ON USING CLEANING AGENT/PAINTS .

Recycling:

Carry out the cleaning operation in a suitable washing bay as the emerging cleaning agent leaks through the drain openings in the transmission tunnel.

Preliminary work needed:

To avoid dirtying vehicle interior:

Close all the ventilation outlets
Set air conditioning to recirculated-air mode
Cover carpet in work area
F39, F4x, F5x: Remove UNDERBODY PROTECTION .
All vehicles: Remove MICROFILTER FOR PASSENGER COMPARTMENT VENTILATION .

Courtesy of BMW OF NORTH AMERICA, INC.

Open flap (1).

Insert special tool 2 413 653 into the microfilter housing (2) as shown.

Courtesy of BMW OF NORTH AMERICA, INC.

Position special tool 2 413 653 up against the top right limit position as shown.

Shift special tool 2 413 653 from right to left (1) to the stop.

Shift special tool 2 413 653 back and forth until the A/C system cleaner has been completely sprayed.

After termination of the cleaning operation:

Let the vehicle drip off for about 5 minutes.
All vehicles: Install MICROFILTER FOR THE INTERIOR VENTILATION .
Set air conditioning to footwell ventilation and fresh air mode. Open side windows/doors.
Start the vehicle and let the air conditioning run for approx. 5 minutes at maximum blower output.
F39, F4x, F5x: Install UNDERBODY PROTECTION .
l01: Install thrust field.
In order to eliminate last remnants of cleaning agent, repeat steps 3 and 4 before handover to the customer.