Installing the seat cover for the rear seat

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.

Position the seat cover on the cushion.
Secure all trim wires with the clamps.

Courtesy of BMW OF NORTH AMERICA, INC.
Replace the clamps (2).
Parts: Clamps
Insert the clamp (2) with the special tool 0 492 668 (52 0 050) .
Clasp the trim wire (3) of the cushion (1) and the trim wire (4) of the backrest covering with the clamp (2) and bend the clamp (2).

Courtesy of BMW OF NORTH AMERICA, INC.
Thread the seat cover over the seat frame in the arrow direction.
Connect and lock all connectors present, if any.

Courtesy of BMW OF NORTH AMERICA, INC.
Clip in the seat cover (1) in the arrow direction.

Courtesy of BMW OF NORTH AMERICA, INC.
Make sure that the clamps (marks) are in place and not damaged.
The clamps must snap in noticeably.

Courtesy of BMW OF NORTH AMERICA, INC.
Clip in the edge stripping in the marked area.

Courtesy of BMW OF NORTH AMERICA, INC.
Pull the ISOFIX trims through the foam cushion.
Clip in the ISOFIX glares (1).
Make sure that the detent of the ISOFIX trims (1) are correctly locked in place.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to INSTALLING THE REAR SEAT BENCH .
Refer to INSTALLING THE LUGGAGE COMPARTMENT FLOOR COVERING .
Refer to INSTALLING HOOK AND LOOP TAPE FOR THE VEHICLE TOOL KIT .
Refer to INSTALLING TOOLKITS .
Refer to INSTALLING THE EMERGENCY WHEEL .
Refer to INSTALLING THE LUGGAGE COMPARTMENT REMOVABLE PANEL .