Removing the lumbar support with pump
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
Preliminary work
- Refer to REMOVING THE FRONT STRAP FITTING .
- Refer to REMOVING FRONT SEAT .
- Refer to REMOVING INNER COVER FROM THE FRONT SEAT .
- Refer to REMOVING THE COVER FOR THE BACKREST ADJUSTMENT .
- Refer to REMOVING THE TRIM PANELS FOR THE HATCH IN THE FRONT SEAT BACKREST .
- Refer to REMOVING SIDE AIRBAG FROM FRONT SEAT .
- Refer to REMOVING THE BACKREST COVER WITH THE CUSHION .
- Unlock plug connection (1) and disconnect.
- Unclip the pneumatic lines from the brackets in the marked areas.
- Release the valve unit (2) from the spring wire.
- Release cable tie (1).
- Unlock plug connection (2) and disconnect.
- Feed out the pump (3).
- Release and remove the lumbar support (1) from the spring wire in the marked areas (2).