Replacement: Preparing the intake camshaft

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.

Affix the intake camshaft with a standard open-end wrench (1) .
Loosen screw (2) .
Remove the camshaft sensor wheel (3) .

Courtesy of BMW OF NORTH AMERICA, INC.
Insert and install the camshaft sensor wheel (3) .
Ensure that the camshaft sensor wheel (3) is correctly positioned on the guide pin (4) .
Affix the intake camshaft with an open-end wrench (1) .
Tighten down screw (2) .

TIGHTENING TORQUE SPECIFICATIONS

Camshaft sensor wheel to intake camshaft
M6x16 Replace screw.	1. Tightening torque	5 Nm
	2. Angle of rotation	90°

Courtesy of BMW OF NORTH AMERICA, INC.