Removing and installing/replacing front anti-roll bar (X2 2018-2023)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
Removal:
Release screws (1) from anti-roll bar.
- Lower FRONT AXLE SUPPORT .
Loosen screws (1).
Remove heat shield (2).
Disengage and remove anti-roll bar (1) with retaining brackets on the front axle.
Installation:
If necessary, remount retaining bracket (1) to new anti-roll bar (2).
Position anti-roll bar (1) on the front axle support.
Replace screws (1).
Parts: Screws
Screw in the screws (1) by a few turns.
Position heat shield (2).
Replace screws (1).
Parts: Screws
Tighten down screws (1).
Tightening torque 32 00 2AZ .
- Raise FRONT AXLE SUPPORT .
Tighten screws (1) of anti-roll bar.
Tightening torque 31 35 3AZ .