Remove The Outer Section Of The B-Pillar

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.

Mark and cut the separating cut (1) to dimension (a). Thereby disconnect only the outer panel.
Dimension (a) = 200 mm from the edge of the roof frame.

Courtesy of BMW OF NORTH AMERICA, INC.
Mark and cut the separating cuts (1) and (2) according to the specified dimensions and carry out the cuts.
Thereby disconnect only the outer panel.

Dimension (a) = 110 mm from centre of hole Ω 20 mm.

Dimension (b) = 20 mm from centre of hole Ω 20 mm.
Open welded connections in area (3) .

Courtesy of BMW OF NORTH AMERICA, INC.
Release welded connections in areas (1).
Release the outer section of the B-pillar from the cavity sealing (2) and remove.

Courtesy of BMW OF NORTH AMERICA, INC.