Prepare New Part
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
- Remove adhesive residue from joining surfaces of the vehicle.
- Mark and cut the separating cut (1)
on the new part as per the separating cut on the vehicle.
- Open the welded connections in the areas (1)
and remove the side sill reinforcement panel (2).
- Adjust the new part using an alignment bracket or a universal fixture and secure it.NOTE: TECHNICAL INFORMATION
For additional information see: 41 00... Welding in reinforcement plates (sheet steel) - Make a reinforcement plate (1) for the separating cut.
- Prepare areas (2)
for joining by welding.
- Prepare the areas (1)
and (2)
for joining by welding.NOTE: TECHNICAL INFORMATION
For additional information see: 41 00... Spot-weld bonding steel components - In area (2), observe the procedure for the replacement of spot-welded adhesive joints for the series.
- Prepare for joining by welding in areas (1).
- Mark and make the separating cuts on the new part A-pillar outer skin in accordance with the separating cuts on the vehicle.
- Adjust the new part outer skin of the A-pillar and reinforcement plates.
- Prepare the new part A-pillar outer skin and reinforcement plate (1)
in area (2)
for joining through welding.
- Prepare the new part and the reinforcement plate (1)
for joining by welding in the areas (2)
and (3)
.NOTE: TECHNICAL INFORMATION
For additional information see: 41 00... Spot-weld bonding steel components - In area (3), observe the procedure for the replacement of spot-welded adhesive joints for the series.
Renew T-bolt
NOTE: Schematic diagram is for example purposes. Some parts may differ in certain details. - Take the quantity and position from the component to be renewed.
- Renew T-bolts (1).
Parts: T-bolt
- Weld the T-bolt (1)
onto the new part.