Preparing New Part

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: TECHNICAL INFORMATION
Adhesive technology in the area of the outer skin (not for structural adhesion): The bonding surfaces of the new parts may not sharpened or ground. For more information see: 41 00... BMW bonding instructions

Adjust the luggage compartment floor in combination with side panel and tail panel to fit and secure.
Prepare the joints in areas (1) and (2) using the bond-and-rivet method.
In areas (1) and (2) drill out 5 bores to dia. 4.2 mm for blind rivets.

Courtesy of BMW OF NORTH AMERICA, INC.
Prepare the joints in areas (1) and (2) using the bond-and-rivet method.
In areas (1) and (2) drill out 6 bores to dia. 4.2 mm for blind rivets.

Remove new component. Deburr bores.

Courtesy of BMW OF NORTH AMERICA, INC.

Replacing the coarse thread bolt and threaded weld bolts (steel surface)

NOTE: Schematic diagram is for example purposes. Some parts may differ in certain details.

Renew the coarse thread bolt (1) and the threaded weld bolt (2).
Parts: Coarse thread bolt, threaded weld bolt

Take the number and position from the component to be replaced or the add-ons.

Weld the coarse thread bolt (1) and threaded weld bolt (2) onto the new part.

Courtesy of BMW OF NORTH AMERICA, INC.