Removing The Luggage Compartment Floor And Right Side Member

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.

Release the welded connections (1) of the holder (2).

Courtesy of BMW OF NORTH AMERICA, INC.
Mark and make the separating cut (1) as shown. Do not cut through the holder (2) on the bottom when doing so.
Release the welded connections in the areas (3) and remove the luggage compartment floor.

Courtesy of BMW OF NORTH AMERICA, INC.
Release the welded connections in the areas (1) to (3) .
Release the welded connections in the areas (2) and (3) from the inside.

Courtesy of BMW OF NORTH AMERICA, INC.
Release the welded connections in the areas (1) and (2) remove the luggage compartment floor.

Courtesy of BMW OF NORTH AMERICA, INC.
Make the separating cut (1) according to the schematic diagram. Cut through side rail completely and remove it.
Loosen welded connections in areas (2).

Courtesy of BMW OF NORTH AMERICA, INC.
Mark and carry out a separating cut (1) according to dimension (A). Only cut through the outer panel.
Dimension (A)= 55 mm from the component edge of the wheel well.
Release the welded connections in areas (2) and remove the side member section.

Courtesy of BMW OF NORTH AMERICA, INC.