Remove Engine Mount

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.

Mark and make a separating cut according to the dimension a. In doing so, only disconnect the inner panel of the engine mount.
Dimension a = 75 mm from the edge of the recess.
Loosen welded connections in areas (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Release the welded connections in the area (1) of the separating cut.
Mark and make the separating cut (1) according to dimension a.
Dimension a = 25 mm from the center of the hole "0 20 mm.

NOTE: A bulkhead is below the separating cut. The bulkhead will also be renewed. The bulkhead on the new part will be used as reinforcement plate.
Remove section of engine mount.

Courtesy of BMW OF NORTH AMERICA, INC.