Installing the BMW badge on the rear side panel
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
TECHNICAL INFORMATION
Notes on component bonding using adhesive tape form the basis for these repair instructions and must be observed without fail.
For additional information see: NOTES ON COMPONENT BONDING WITH ADHESIVE TAPE .
Notes on component bonding using adhesive tape form the basis for these repair instructions and must be observed without fail.
For additional information see: NOTES ON COMPONENT BONDING WITH ADHESIVE TAPE .
- Replace the BMW badge.
Parts: BMW badge
- Remove any adhesive residue from the body and clean the bonding surface (1) with the cleaning agent R2.CONSUMABLE SPECIFICATION
Cleaning agent R2 500 ml 83190417324 - Check the guide pins (2).
The guide pins (2) must not be damaged or missing.
- Replace the grommets (3).
Parts: Grommets
- Coat the guide pins (2) using G14 lubricant.INSTALLATION AID
Lubricants G14 900 ml, Can 83232360412 - Pull off the liner (protective film) from the adhesive tape of the badge.
- Press the BMW badge (1) onto the guide pins (2) and press on to the adhesive strip.