Install the bottom C-pillar trim panel

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.

Check clips (1) for damage, and replace if necessary,
Check the clamps (2) for damage, and replace if necessary.

Courtesy of BMW OF NORTH AMERICA, INC.
Insert the end fitting (2) through the C-pillar trim panel.

Mount the end fitting (2) and tighten the screw (1).

TIGHTENING TORQUE SPECIFICATIONS

End lining to body
Screw Replace screw.	Tightening torque	42 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Install the carpet correctly.
Clip in the C-pillar trim panel on the bottom (3) with the clamps (2) and the clips (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Position the edge protection (1) correctly in the area of the bottom C-pillar trim.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to INSTALLING THE REAR DOOR SILL COVER STRIP .