Prepare for the installation of the DSC control unit
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
TECHNICAL INFORMATION
Maintain conditions of absolute cleanliness.
Maintain conditions of absolute cleanliness.
NOTE:
TECHNICAL INFORMATION
Do not clean the sealing surface with compressed air, chemical solvents or sharp-edged objects.
Do not tap or clean the pressure sensor contacts with your fingers.
Do not clean the sealing surface with compressed air, chemical solvents or sharp-edged objects.
Do not tap or clean the pressure sensor contacts with your fingers.
- Clean the sealing surface (1) if necessary, with plastic scraper or a lint-free cloth.
- Ensure that the contacts (2)
are not damaged.
- Attention: For reuse of the hydraulic unit (valve block), an add-on control unit repair kit is required.
The repair kit contains a new silicone seal (1) and bolts.
- Make sure that the valve coils (2)
are not damaged.
Do not clean, readjust or touch the valve coils with your fingers.
- Check the DSC control unit (3) for damage and replace if necessary.