Install EMF actuator

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.

Carefully fit the EMF actuator until the gearing engages and the EMF actuator rests flush against the brake caliper.
If necessary, turn the EMF actuator slightly until the bore hole and the screw thread are aligned.

Courtesy of BMW OF NORTH AMERICA, INC.
Replace screws 1.
Parts: Screws
Position and tighten the screws (1) at the EMF actuator (2).

TIGHTENING TORQUE SPECIFICATIONS

EMF actuator to brake caliper
Replace screws.	Tightening torque	8 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Connect connector (1).
Attach the cable (2) to the bracket.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to AFTER EMF ACTUATOR REPLACEMENT: PUTTING ELECTROMECHANICAL HOLDING BRAKE INTO OPERATION .