Install hydraulic unit
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
- Position hydraulic unit (4) .
- Replace the screw (3)
.
Parts: Screw.
- Position and tighten the screw (3) .
TIGHTENING TORQUE SPECIFICATIONS
| Hydraulic unit with holder on body | ||
| Replace screws. | Tightening torque | 8 Nm |
NOTE:
TECHNICAL INFORMATION
Do not interchange brake lines. If necessary, mark the brake lines before disassembly.
Note various equipment specifications with different line seizure.
Do not bend brake lines.
Close off connecting bores with seal plugs.
Do not interchange brake lines. If necessary, mark the brake lines before disassembly.
Note various equipment specifications with different line seizure.
Do not bend brake lines.
Close off connecting bores with seal plugs.
- Fit brake lines (2) and tighten.
TIGHTENING TORQUE SPECIFICATIONS
| Brake pipe screw connection/Union screws | ||
| Tightening torque | 17 Nm | |
- Connect the plug connection (1) .
Follow-up work
- Refer to REMOVING THE BRAKE PEDAL TENSIONER .
- Refer to INSTALLING THE REAR COWL PANEL .
- Refer to INSTALLING LEFT AND RIGHT WIPER ARM .
- Refer to CONNECTING THE BRAKE FLUID BLEEDER UNIT (AFTER REPAIR) .
- Refer to FLUSHING AND BLEEDING THE REAR AXLE BRAKE CIRCUIT .
- Refer to FLUSHING AND BLEEDING THE FRONT AXLE BRAKE CIRCUIT .
- Refer to DISCONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID (AFTER REPAIR) .
- Refer to INSTALLING FRONT WINDSHIELD PANEL COVER .
- Refer to INSTALLING THE GUTTER STRIP ON THE WINDSCREEN ON THE LEFT AND RIGHT .
- Refer to INSTALLING THE REAR HOOD SEAL .
- Refer to DSC UNIT START-UP/DRIVING DYNAMICS SENSOR ADJUSTMENT/CONTROL UNIT PROGRAMMING .